You need a pair of scissors, cotton balls, water and the two different sheets you received: a clear decal tattoo paper sheet (with text "Inkjet/Clear waterslide decal paper" or "Inkjet Tattoo Paper Printing Paper" on the back) and a adhesive sticker sheet.

1. Arrange the designs with any graphic software program on a page (size 10.5x15 cm - 4x6 inch). Don't forget to mirror the images if necessary (always mirror names, texts, numbers, banners and any other design that is not symmetric).
2. It is recommended that you print your design on a plain paper first (size 10.5x15 cm - 4x6 inch) before using the waterslide removable tattoo paper. REMARK:The water slide temporary tattoo paper should be fed into your printer one sheet at the time. You should also remove all other paper from your printer. This is to avoid a paper jam in the printer because the tattoo paper is thicker than regular print paper.
3. Print on the glossy side of the decal tattoo paper. When using laser printer paper: Use the manual feed to insert the paper
4. Wait until the the paper has cooled down (laser priner) and the ink is fully dry (2 - 3 minutes).
5. Remove the front side of the adhesive sticker sheet.
6. Apply the adhesive sticker sheet to the printed side of the tattoo sheet. Be sure to remove all air bubbles.
7. Use scissors to cut around each individual tattoo design, as close as possible to the design.
8. Remove the adhesive backing from the tattoo paper.
9. Apply the tattoo on your skin and press firmly for 20 seconds. The skin must be clean, dry and free of hair.
10. Wet the tattoo with a damp cloth for 60 seconds. Make sure the tattoo is thoroughly wet.
11. Remove the paper to reveal the tattoo.